TEXTURE PAINT TYPES

Texture Paint

Types of Texture Application:

1) Ruf –Tuf Texture: - Coat of Acrylic Quartz Granule coatings shall then be applied with trowel and then grooved with a specially designer trowel according to the specified design. This coating would be approximately up to 2.5mm according to the wall condition. This application is recommended for preventing the dampers and to be applied on exterior walls to give maximum integrity to the walls. It is washable – waterproof.

Note: There are various other types of textured paint available which can be used as suggested by Architect / Interior Designer.

Textured Paint

Synthetic Resin Base Coat with Acrylic Overcoats (renova) in Plain / Stone / Metallic finish (Application Procedures):

1)     The surface shall be thoroughly cleaned off all dirt, dust, mortar dropping and other foreign matter, before paint is to be applied.

2)    Application of primer coat is necessary over the entire surface to be texture painted.

3)     Synthetic plaster reinforced by using fibers and based on a chemical which is superior type of cladding material having acid and alkali resistant properties, can be applied to any hard based plain surface both internally and externally. It does not require any further application or treatment once it is applied on the surface. It is available ready-mixed for any desired colors which can be applied by a trowel. This will avoid cracks formation as well as provide a waterproofing coating on the surface treated.

4)    A cement plaster base is required which shall be roughened lightly with wire brush so as to form very mild keys. The surface shall be well cured before the application of synthetic plaster.

5)    Synthetic plaster then be applied in five coat i.e. one coat of plaster by trowel and subsequent four coats of

chemical overcoat by brush in approved color and finish as specified (plain / stone or metallic).